Variable power settings to clean everything from hard floors to thick carpets.

Don’t use soap..Allow the filters to air dry for at least 24 hours.. How to Clean Your Shark’s Filters.

Step 1: Switch Off and Unplug the Vacuum.Never clean a vacuum’s filter when the vacuum is switched on or plugged in.You also shouldn’t use the vacuum with the filter removed, as this allows dust, pet dander, and other particles to clog the motor and escape into the air.. We always recommend washing filters outdoors if possible.

Any loose dirt or other particles on the filter will escape into the air when it’s removed..Step 2: Locate and Remove the Shark Vacuum’s Filters.

have a pre-motor filter and a post-motor filter.

The pre-motor filter is typically a combination of foam and felt, while the post-motor is either a foam or.You may need to check the manual to find out how to remove the hose (or if it’s even possible to do so,) as this process isn’t always obvious..

If you find any blockages, then use a broom stick to gently dislodge them, before rinsing with cold water.. Make sure the hose is completely dry before reattaching it.A damp hose will cause dirt to stick to the sides and could allow mould to grow inside the vac.. Related.

How to Clean a Clogged Vacuum Hose.Clean the Vacuum Exterior.