Removing bed bugs from surfaces where it would be unsafe to use an insecticide..

Remember to test a small area with the solution (and let it fully dry) before you remove stains.. For this method, you’ll need to mix a small amount of distilled white vinegar with warm water in a spray bottle.dilution ratio should be around 1:20. , which is approximately one teaspoon of vinegar for every 100ml of water..

Begin by using a damp cloth to dab up as much of the stain as possible.Don’t rub the stain though, as this can damage the fibres and force the stain deeper into the carpet.. Then, using a new cloth, dab the entire area with the vinegar solution before leaving it for around 10 minutes.. Next, rinse the area with a clean cloth using cold water, then blot up the liquid with a microfiber cleaning cloth.You may need to repeat this sequence multiple times to remove the entire stain.. Continue blotting until all excess moisture is removed, then allow the carpet time to air dry..

Tip: Make sure you don’t oversaturate your carpet during the cleaning process.It should be damp rather than wet.. 3.

Washing Up Liquid And Vinegar.

For this method, you will need the following:.Use the process above to remove the dust cup from the vacuum’s body, empty it into a bin, then with the lid open rinse the cup in cold water (don’t use any cleaning products or a dishwasher).

Leave the lid open and place the cup on its side to allow it to dry for at least 24 hours.. Shark sells replacement filters for the CH950UKT.The filters should last a long time, but if they become torn or otherwise damaged then it’s important to replace them.. Summary.

The Shark CH950UKT is a powerful handheld vacuum cleaner that’s great for cleaning up pet hair.It’s important to keep the filters clean, however, to ensure that the vacuum doesn’t lose suction strength over time.. Here’s a quick summary of how to clean the Shark CH950UKT’s filter:.